Heat Pump Leaking Water or Not Working?
- Free written quote, no obligation
- Licensed electrician on the connection
- Auckland-wide, all major brands
Get a free quote
Free written quote. No obligation. We reply by phone.
Sorry, that did not send. Please try again in a moment.
Thanks, we have your request
We will call you back about your free written quote.
If water drips from the indoor unit, switch the heat pump off and get a technician in, because a blocked drain is the usual cause and it will not clear itself. If the unit will not start or blows cold air, five quick checks fix many cases. Our team repairs all brands across Auckland, and you can get a free quote for the fix.
Heat pump leaking water inside: the causes
Water inside is almost always a drain problem. A heat pump pulls moisture out of the air, and that condensate runs to a drain tray and out through a hose. When the route is blocked, the water has nowhere to go and drips from the indoor unit. The usual causes:
- A blocked drain hose. Dust, mould slime, insects and spider webs build up, especially at the outlet.
- A kinked or crushed hose, often after building work or a pipe re-route.
- A dirty coil or drain tray, where grime stops water draining cleanly.
- Poor fall on the drain. If the hose is not sloped down all the way, water pools.
- A frozen coil. Low airflow from dirty filters can ice the coil, and the ice melts and overflows the tray.
Auckland humidity makes this more common. The unit pulls a lot of water out of damp air in winter and while cooling in summer, so a partly blocked drain overflows here.
What to do about a leak
- Switch the unit off at the remote and at the wall.
- Put a towel or a bucket under the drip, and move anything electrical out of the way.
- Wash the filters and refit them dry.
- Check the drain hose outlet outside. If it is kinked, blocked or sitting in a puddle, free it gently.
- If it still leaks, ask us to take a look. Do not keep running it, because water can reach the circuit board and cause water damage to the wall or floor.
We clear the drain, clean the tray and coil, check the fall and test the unit before we leave. See heat pump repairs for how a callout works.
Leaks from different types of unit
Wall units usually drip along the bottom edge or from the pipe cover. Floor-mounted units can leak onto the carpet near the skirting, from the same blocked drain. Ceiling cassettes and ducted units use a condensate pump in some installations, and a failed pump lets water back up into the ceiling, which can stain the lining. If you see a brown stain spreading on a ceiling below a ducted or cassette unit, switch the system off.
Water outside is usually normal, and the outdoor unit stays uncovered
In heating mode the outdoor coil gets cold and sheds condensation, and in a defrost cycle the ice melts and runs out of the base. You may also see steam rising from the unit on a cold morning. That is the unit working correctly. Do not cover the outdoor unit, because it needs airflow, and a cover can trap moisture. Dry mode, which dehumidifies the room, also sends water to the drain. Get help only if the outdoor unit is leaking oil or the ice does not clear.
Heat pump not working: five quick checks
- Mode and temperature. The unit must be in heat mode with the set temperature above the room temperature.
- Remote batteries. Weak batteries stop the signal reaching the unit.
- Power. Check the switchboard for a tripped breaker and look for a wall isolator switch near the outdoor unit.
- Filters. Blocked filters cut airflow and can stop the unit running.
- Airflow. Make sure nothing blocks the front of the indoor unit or the back and sides of the outdoor unit.
If it still does not work, switch it off at the remote and then at the wall, wait five minutes and restart it. Do not keep resetting it, because that can hide a fault.
Heat pump blowing cold air
A heat pump blows cool air for a short time at the start of heating and during defrost. Give it a few minutes. If it keeps blowing cold air, the likely causes are:
- Wrong mode. It may be in fan, dry or cool mode.
- Dirty filters or a dirty coil that cut the heat output.
- A blocked or iced outdoor unit that cannot pull heat from the air.
- Low refrigerant from a leak. This needs a technician.
- A fault in a sensor, fan or compressor.
If the unit is old, ask whether a repair or heat pump replacement makes more sense.
Flashing lights and fault codes
A flashing light often reports a fault, and the pattern points to the cause. Count the flashes, note the brand and model and check the manual. Our remote symbols and flashing lights guide lists the common patterns and says which ones are normal.
Rentals
A heat pump that does not work leaves tenants without heating, so landlords should fix faults promptly. Tenants should report a leak or a dead unit to the landlord or property manager in writing. We attend for landlords and property managers. See Healthy Homes heating.
Faults that need a technician
- Loud grinding, rattling or banging
- The unit trips the breaker
- A burning smell
- Ice building up on the outdoor unit that does not clear
- A refrigerant leak or oily residue on the pipes
- Repeated cutting out after a restart
Switch the unit off and leave it off if you smell burning or it trips the breaker more than once.
Stop it happening again
A yearly service is the best protection. We clean the filters, coil and drain, check the drain fall and test the unit. Between visits, wash the filters every month, keep the outdoor unit clear and check the drain outlet. A deep clean helps in damp or pet-heavy homes, and coastal homes benefit from a check of the outdoor coil for salt.
Get it fixed
Tell us the brand, the model and what you can see. A photo of the drip or the flashing lights helps. We quote any repair before we start.
Talk to a person about this job.
Questions
Why is my heat pump leaking water inside?
The usual cause is a blocked or kinked drain line, or a dirty coil and drain tray that cannot carry the condensation away. A pipe fitted with too little fall can also cause it. Switch the unit off and get a technician to clear the drain.
Is it normal for water to come out of the outdoor unit?
Yes. The outdoor unit sheds condensation and defrost meltwater through the base, and Auckland's damp winters make this common. Water dripping from the indoor unit is not normal.
Why is my heat pump blowing cold air?
Check the mode and set temperature first. A unit that has just started or is defrosting blows cool air for a few minutes. If it stays cold, the cause could be dirty filters, a blocked outdoor unit or low refrigerant from a leak, which needs a technician.
Can I fix a leaking heat pump myself?
You can switch it off, wash the filters and check the drain hose outlet is not blocked or kinked. Do not open the unit or run water through it, because the coil sits close to the electronics.
How do I get a leaking heat pump fixed?
Send us the brand, the model and a photo of the drip. We find the cause and quote the repair in writing before we start. Get a free quote through our contact page.
Why does a new heat pump leak water?
Usually the drain hose is kinked or has too little slope, or the indoor unit is not level. Contact the installer so it can be corrected.
Can a leaking heat pump damage my home?
Yes. Water running down a wall or into a ceiling can stain linings and damage floors and electrics. Switch the unit off and get it checked quickly.
Why does my heat pump leak only in summer?
In cooling mode the indoor coil is cold and collects more condensation, so a partly blocked drain overflows. A service and drain clear usually fixes it.
Should the outdoor unit be covered?
No. Covering it blocks airflow and traps moisture. Keep leaves and clutter clear of it instead.
Get a free quote
Tell us the address and the job. We will call you back.
Request a callbackFree written quote. Licensed electrician. Auckland-wide.
Tell us about the job
Free written quote. No obligation. We reply by phone.
Sorry, that did not send. Please try again in a moment.
Thanks, we have your request
We will call you back about your free written quote.